Embertec Emberplug EPUSAV-ET-01 Guide d'installation télécharger pdf (Page 11)

Turning ON your AV Equipment

To operate your Audio Visual (AV) components, press any button on any •

existing remote control(s), or press the button on the SmartSensor. This

will apply power to all components and place them in standby mode,

ready for use. You can continue using your existing remote(s) to operate

your television or other Audio Visual (AV) components in the normal way.

NOTE: To reactivate your TV components, you may be required to press

the power button again on the relevant remote control after power has

been restored.

Turning OFF your AV Equipment

Simply turn your equipment o in the normal way. Once the Audio Visual •

(AV) components have been switched o, the Embertec Emberplug™

will remove power from the Power Saver socket after a delay of

approximately 1 minute.

NOTE: The LED light on the SmartSensor will ash for about 60 seconds

to warn you that power is about to be removed from the AV 'Power

Saver' socket.

SmartSensor

The SmartSensor receives signals from any of your remote controls

and recognises when you are interacting with your Audio Visual (AV)

components. The SmartSensor is also used to get the time period for

the Active Powerdown feature. SmartSensor default setting for Active

Powerdown is 60 minutes.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Embertec Emberplug EPUSAV-ET-01 Guide d'installation Page 11